Operation Manual

Prior to installation, the customer must check for damages with the freight company before the unit is accepted.

Open Display Merchandisers are designed to be in an area that is ambient 75 degrees Fahrenheit (dry bulb) or colder with 55 percent relative humidity. If the installed unit is in a warm ambient area, it may not be as effective. Position the Merchandiser at its final location before removing the shipping skid. There are four bolts at the bottom of the merchandiser that secure the shipping skid. Remove all four bolts to remove the skid.

Overloading of product or placing products against the back wall or suction grill may cause. disruption in air flow, which may cause the unit to not cool properly.

Always turn off your unit (both power and lights) when cleaning. Remove all products and allow your unit to reach room temperature. Do not allow electrical components to get wet.

• a. Do not clean with harsh detergents. Use mild soap.
• b. Remove all products.
• c. Remove shelves and bottom trays.
• d. Clean interior with warm water and mild detergent.
• e. Wipe with damp cloth. Do not leave soap residue.

• Condenser coil is located at bottom behind panel.
• 1. Disconnect the electrical power from the unit.
• 2. Remove the front cover and base cover with screw driver.
• 3. Brush the dirt, lint, etc. from the finned condenser coil.
• 4. When finished, be sure to reinstall the front cover and base cover.
• 5. Reconnect the electrical power to the unit.

For any problems with your unit, please refer to the following check list.

• Ⅰ. MERCHANDISER NOT FUNCTIONING
• a. Check to see that the store breaker hasn’t tripped.
• b. Check that enough power is BEING supplied to the unit.
• c. Check that the power switch is on.
• Ⅱ. MERCHANDISER IS WARM
• a. Check the condenser to see if it is clean. b. Check that the inner airflow is not being blocked by products.
• Ⅲ. LIGHTS ARE NOT WORKING
• a. Check that light switch is on.